LTM4613
APPLICATIONS INFORMATION
? V OUT(P ? P) ≈ ?
? ? +
to12Vdesign.Thedutycycleisabout0.33.The2-phase
curve shows a ratio of ~0.33 for a duty cycle of 0.33. This
0.33 ratio of output ripple current to the inductor ripple
current ?I L at 5.0A equals 1.65A of the output ripple cur-
rent (?I O ).
The output voltage ripple has two components that are
related to the amount of bulk capacitance and effective
series resistance (ESR) of the output bulk capacitance.
The equation is:
? ? I O ? ESR ? ? I O
? 8 ? f ? N ? C OUT N
Where f is the frequency and N is the number of paral-
leled phases.
another regulator can be easily tracked.
Output Voltage Tracking
Output voltage tracking can be programmed externally
using the TRACK/SS pin. The output can be tracked up
and down with another regulator. Figure 5 shows an ex-
ample of coincident tracking where the master regulator’s
output is divided down with an external resistor divider
that is the same as the slave regulator’s feedback divider.
Ratiometric modes of tracking can be achieved by selecting
different resistor values to change the output tracking ratio.
The master output must be greater than the slave output
V IN
LTM4613
Fault Conditions: Current Limit and
Overcurrent Foldback
LTM4613 has a current mode controller, which inherently
limits the cycle-by-cycle inductor current not only in steady
state operation, but also in transient.
To further limit current in the event of an overload condi-
tion, the LTM4613 provides foldback current limiting. If the
output voltage falls by more than 50%, then the maximum
output current is progressively lowered to about one sixth
of its full current limit value.
MASTER
OUTPUT
TRACK
CONTROL
C IN
R2
100k
R1
5.23k
51k
10μF
× 3
V D V IN PLLIN
PGOOD V OUT
DRV CC MARG1
f SET MPGM
TRACK/SS
SGND PGND
RUN V FB
COMP FCB
INTV CC MARG0
R FB
5.23k
4613 F05
SLAVE
OUTPUT
C OUT
Soft-Start and Tracking
Figure 5. Coincident Tracking
The TRACK/SS pin provides a means to either soft-start
the regulator or track it to a different power supply. A
capacitor on this pin will program the ramp rate of the
output voltage. A 1.5μA current source will charge up the
external soft-start capacitor to 80% of the 0.6V internal
voltage reference plus or minus any margin delta. This will
control the ramp of the internal reference and the output
voltage. The total soft-start time can be calculated as:
OUTPUT
VOLTAGE
MASTER OUTPUT
SLAVE OUTPUT
t SOFTSTART ? 0.8 ? ( 0.6 ± 0.6 ? V OUT Margin % ) ?
C SS
1.5μA
TIME
4613 F06
If the RUN pin falls below 2.5V, then the soft-start pin
is reset to allow for the proper soft-start again. Current
foldback and force continuous mode are disabled during
the soft-start process. The soft-start function can also
be used to control the output ramp rising time, so that
14
Figure 6. Coincident Output Tracking
4613f
相关PDF资料
LTM4614IV#PBF IC UMODULE DC/DC DUAL 4A 144LGA
LTM4615IV#PBF IC SWIT REG BUCK 4A ADJ 144LGA
LTM4618IV#PBF IC DC-DC UMODULE BUCK 6A 84-LGA
LTM4619IV#PBF IC SWIT REG BUCK 4A ADJ 144LGA
LTM4627MPY#PBF IC DC/DC UMODULE 15A 133-BGA
LTM4628EV#PBF IC DC/DC UMODULE 16A 144-LGA
LTM8008HV#PBF IC DC/DC UMODULE 16-LGA
LTM8020IV#PBF IC DC/DC UMODULE 200MA 21-LGA
相关代理商/技术参数
LTM4614 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual 4A per Channel Low VIN DC/DC μModule Regulator
LTM4614EV 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual 4A per Channel Low VIN DC/DC μModule Regulator
LTM4614EV#PBF 功能描述:IC UMODULE DC/DC DUAL 4A 144LGA RoHS:是 类别:电源 - 板载 >> DC DC Converters 系列:µModule® 设计资源:VI-200, VI-J00 Design Guide, Appl Manual 标准包装:1 系列:* 类型:隔离 输出数:1 电压 - 输入(最小):66V 电压 - 输入(最大):160V Voltage - Output 1:12V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出(最大):* 电源(瓦) - 制造商系列:50W 电压 - 隔离:* 特点:* 安装类型:通孔 封装/外壳:9-FinMod 尺寸/尺寸:4.60" L x 1.86" W x 0.79" H(116.8mm x 47.2mm x 20.1mm) 包装:散装 工作温度:-25°C ~ 85°C 效率:* 电源(瓦特)- 最大:*
LTM4614EV#PBF 制造商:Linear Technology 功能描述:DC/DC Module IC
LTM4614EVPBF 制造商:Linear Technology 功能描述:Dual 4A Channel DC/DC UModule Regulator
LTM4614IV 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual 4A per Channel Low VIN DC/DC μModule Regulator
LTM4614IV#PBF 功能描述:IC UMODULE DC/DC DUAL 4A 144LGA RoHS:是 类别:电源 - 板载 >> DC DC Converters 系列:µModule® 设计资源:VI-200, VI-J00 Design Guide, Appl Manual 标准包装:1 系列:* 类型:隔离 输出数:1 电压 - 输入(最小):66V 电压 - 输入(最大):160V Voltage - Output 1:12V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出(最大):* 电源(瓦) - 制造商系列:50W 电压 - 隔离:* 特点:* 安装类型:通孔 封装/外壳:9-FinMod 尺寸/尺寸:4.60" L x 1.86" W x 0.79" H(116.8mm x 47.2mm x 20.1mm) 包装:散装 工作温度:-25°C ~ 85°C 效率:* 电源(瓦特)- 最大:*
LTM4614IVPBF 制造商:Linear Technology 功能描述:Conv DC-DC Dual Step-Down 5.5V LGA144